Same thing happened to me, in a fit of impatience I used a short phillips hex bit and it pushed in too far and got stuck. My concern is that just a speck of epoxy getting into the wrong place would essentially make the tool useless. It will make lots of grit dust. You can’t post answers that contain an email address. This has happened to me on occasion with my Makita impact driver. It does seem strange but it works!

Uploader: Malarg
Date Added: 7 October 2016
File Size: 57.38 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 80567
Price: Free* [*Free Regsitration Required]

Results 1 to 2 of 2. It’s worth a thousand words.

Answer questions, earn points and help others Answer questions. Posted by howell on Oct 11, Dewalt 18v Battery Hammer Drill Login to post Please use English characters only. Are you a Dewalt Drill Expert? Your answer needs impadt include more details to help people.

SOLVED: Stuck bit I have a hex bit stuck in the quick real – Fixya

Originally Posted by Dan Lautner. Sponsored Forums Private Forums Authors. If the hole around the bit is wet, you may have drilled into an iron pipe, if it smells it was the sewer drain. SoftballJunky – 3 hours ago. Hi there, Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.


Instant Repair Help over the Phone 6ya. This happens with my Bosch impactor when I use Erwin bits. Posted on Dec 09, Keyless chucks have two parts see pictures when the drill is in operation both parts spin.

All this depends on what impsct used to put the drill bit in with your hand tight or held onto it with something else. DanH – 3 hours ago. I can not get it out. I hope you have got your bit back, but if not, remount the drill chuch onto the bit, and drill in forward without pushing the bit.

I’ve found putting it in rewind holding trigger and beating the tip off whatever is close unbinds it. Posted on Nov 20, Google Sponsor Google Sponsor. Stcuk this does not work you may have to hold the front of the chuck in a vice or with caliper pliers and again the pull the trigger with the drill in reverse. Slide the clip and chuck sleve forward and remove the ball sitting in the spindle.

Drill bit stuck in impact driver…help!

Mine broke because it was too tight of a fit and I locked onto it with a pair of pliers to pull it out. I have two suggestions regarding the chuck stuck: When it is oriented properly the spring presses it toward the back rirgid the tool, not toward the front. Whatever was used should be enough to loosen the chuck Hope this helps. It would’ve gone on to the shelf with my old Craftsman cordless.


Nov 14, Electrical Supplies. I cannot release the bit from the drill.

Google Sponsor Google Sponsor. Yeah that happened to me, I took it in for warranty and they hounored it, basically what happens is the bit gets pushed back past the ball bearing that holds it in in the first place, so the only way to get it out is to take the tool into a place and have them dissassemble the chuck and remove the bit, if you pull on on or try to pry it out yourself ridgld risk damaging the inside components.

It almost seems like there used to be a shim in the bottom of the collet to keep the bits from going in too deep and mine fell out??? A few taps on the nose of the metal part that holds the bit released it.