Input Devices


Arthur Vicente Ribacki Says:. This site in other languages x. In my case my RXD line had less than a volt going to the multimeter or a bad connection. What a whining bunch they can be, huh? I decided to try with […]. Unfortunately the cable reports itself as a low power device. Several places sell chips with a bootloader; Modern Device seems to give you the best deal.

Uploader: Yoll
Date Added: 22 September 2008
File Size: 47.41 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 21094
Price: Free* [*Free Regsitration Required]

A little probing worked out […]. Would you suggest that I try a CA cable? Connect wires 5 and 8 to your multimeter and see if it shows 5V. Added a thread on edaboard — http: How satisfied are you with this response? Earlier in the article I mentioned that my cable had too extraneous wires.

Nokia Dku-5 Serial Cable – mattersapp

Get a free aerial at WordPress. They might help someone else out. I unearthed an old Sony-Ericsson phone cable out of my wonder-cable-box. Proudly powered by WordPress and Carrington. Stay in touch with the conversation, subscribe to the RSS feed for comments on this post.


Do you wish to contribute to other projects regarding computer science, electronics, robotics or mechatronics that will be posted in this blog? I can easily find out which of the 3 wires went ssrial where, but how should I find the pinouts of the other pins?

Apply power to the breadboard. I wish they could do bitbang.

Getting the timing right can be tricky because the bootloader only listens for a brief period of time. RX, TX and 3. Then open a terminal and fire up some serial terminal like screen. The device configuration registers allow you to change settings like the VID, PID, serial number, and maximum power required i.

I do not know how this garbage values comes. Dou explain how to do this in the article. The link from the above post for the drivers is here: To test the cable, plug it into your computer and insert a wire in the housing, connecting Tx to Rx.

Press several keys on the keyboard. Too often there are just a bunch of out of focus smears none of which demonstrate what is being shown. They are really cheap and if you have the oportunity werial order more than one at once, I suggest you to do it because this cables are really useful for lots of projects.


You are commenting using your WordPress.

The BiT Bang Theory

Tell us about your experience with our site. QUOTEJust to close this case for everyone else that might be reading, you cannot use ca with for sure. Depending on the value in the eeprom, the chip will request either ma or ma.

Wear an anti-static wrist strap. Check out his blog too, he posts some cool stuff.

The prolific ones do not work on my laptop Windows 7 bit. Victor March 15, at 2: This means the chip runs the previously uploaded program faster but it also results in a bit of a headache for those that are doing a manual reset upload.