USB devices


At the end of aacraid section is the old information on tools available on Dell website, which may be useful for older distributions and controllers. I haven’t use it much, so here is a quick example of what it can do:. The next screen allows you to choose the type of RAID. A daemon detecting status changes and reporting to syslog as SNMP traps is packaged as cpqarrayd. Supported Supported by Linux kernel?

Uploader: Maucage
Date Added: 17 January 2004
File Size: 50.74 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 89069
Price: Free* [*Free Regsitration Required]

This page requires Javascript. You need to make sure SCSI generic device driver is loaded and liux be loaded at boot. Note – Despite the fact that there are dual paths to disks 1 – 7, they are not shown in the BIOS configuration utility. The utility hides them so that you cannot include the same disk twice in a volume.

HP Workstations for Linux – Installing and Configuring SAS Hardware RAID

Select the desired adapter from the Adapter Selection screen and press start to enter the utility. The array-info tool can extract the RAID status for cciss devices. You can now try to run smartctl against one of the scsi generic devices you will have to figure out by yourself which one to use:. Thank you for your help in advance.


LSIFusionMPT – HWraid

11064e The RPM can be converted to. The driver is in the main kernel as of 2. After this setup process is complete, an operating system can be installed.

Some linux tools are available on a CD included with the controller. Notably this driver uses the kernel scsi subsystem rather than implementing its own block 1064r. The above information applies only to the desktop workstation platforms discussed herein. At any point during RAID configuration or management, press the home button to return to the main screen of the configuration utility.

Management and reporting tools 3.

Status RAID status easily available? If such information is easily available, monitoring tools can be written to detect and report failures. Well, you really have to see it. More details A blog post claim supermicro provide a tool to get the status out from the command line. After the disk has been replaced, it will start with an offline status. Is the kernel driver needed for this RAID system available in linud default kernel?

Running mpt-status without any parameters will give you the same output example as above. Select Manage Array and press Enter to use the management features. In fact, I must admit all my “something-status” packages for others kind of cards are based on this work.

If you need to reset your password, click here. Not all configurations that are made available by the RAID chipsets or plugin cards are supported by HP; only the configurations listed below are supported on HP Linux workstations. There is a precompiled command line tool ipssend available from the vendor CD and IBM’s dumplog archive. A daemon detecting status changes and reporting to syslog as SNMP traps is packaged as cpqarrayd.


Introduction to Linux – A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started guide, with exercises at the end of each chapter. The next screen will display properties of the selected adapter. Recently one of the drives went bad and had to be replaced. In most case, your controller ID will be 0.

When the disks have been marked as desired, press C to create the array. There are Debian packages of both tools available from http: The Virtual Agent is currently unavailable.

We are using Centos 6.